CS92x, CX92x, MS911, MX91x Booklet Finisher (3-Hole)

Considerations

The standard output bin capacity is reduced to 100 sheets when using a floor standing finisher. Bin 2 capacity is reduced when stapling is utilized. Hole punching and offset stacking are supported to Bin 2 only.

Bins 1 and 2 support various plain, recycled or bond papers and glossy paper (16 to 68 lb., 60 to 256 gsm) in A3, A4, Executive, JIS-B4, JIS-B5, Letter, Legal and Ledger (Tabloid) sizes.

The 2500-Sheet Tandem Tray or 2x 500-Sheet Tray is required to raise the printer or MFP to the correct height for use with the Finisher.

Booklet Bin 3

Bin 3, the lower bin, supports paper in A3, A4, JIS-B4, Letter, Legal, Ledger (Tabloid), Super Tabloid (12x18 inch) and SRA3 sizes. This bin, supports saddle stapling of up to 20 sets with up to 3 sheets of folded 20 lb. (75 gsm) paper per set. Or it supports up to 5 sets with up to 20 sheets per set. Bin 3 has a paper present sensor.

Upper Bin 1

The upper bin 1 supports up to 200 sheets of paper with hole punching. Bin 1 has a full sensor.

Middle Bin 2

Bin 2 supports up to 2200 sheets of paper with stapling, hole punching and offset stacking. Each stapled set may contain up to 50 sheets for 4-position stapling (5,000 staples capacity). Bin 2 has a full sensor.